Here are the plan sheets
needed to build the .46 fly-bar.
Print out each page
listed below and tape them together to form the full size plan
sheet.
Top page
Bottom page
** PRINTING NOTE
**
Click on the above links and
when each page has finished downloading. RIGHT click on the image and
select
"Save Picture As..." and note
where you put the image. Then bring up the image and set the printing
options.
as follows; Left Margin 0.5"
and set the Top Margin to 0.5" Then print at
100%.
Check the 2" scale noted
on each page to be sure it has printed at the right size. If not
adjust print size until
you have the 2" scale measuring
2" between the marks.
Cut and prep
the parts as noted on the plans.
Mark the fly-bar for the
bushing.
Then solder each bushing
on both sides.
Here I used the brass
swivel instead of making the fly-bar hooks noted on the
plan.
Here is a look at the finished
fly-bar.
Sand the fly-bar smooth and set it to the side. It will be installed later.
Sand the fly-bar smooth and set it to the side. It will be installed later.
If you have questions
just ask I am always glad to help when I can.
It will also help me (if you have a
problem) to let me know which step your on.
Email your questions or comments to me
at: