Landing gear braces
~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Follow the information provided on the
plan and at this point only cut and prep the parts.
DO NOT Solder anything together until
later.
"Left" Here is
a look at the landing gear brace plan with the parts cut and laid over the
plan.
"Right" This is a larger image of the
brass jointer detail. When the plan calls for mashed brass
there is a good look at how it is
done.
You should complete this step before
moving on to the next step!
** PRINTING NOTE **
Click on the above link and when the page
has finished downloading. RIGHT click on the image and select
"Save Picture As..." and note where you
put the image. Then bring up the image and set the printing
options.
as follows;
Left Margin 0.5" and set the Top Margin
to 0.5" Then print at 100%.
Check the 2" scale noted on the plan to be
sure it has printed at the right size. If not adjust print size
until
you have the 2" scale measuring 2" between
the marks.
If you have questions
just ask I am always glad to help when I can.
It will also help me (if you have a
problem) to let me know which step your on.
Email your questions or comments to me
at:
